Generator Firm Capacity

Units:	MW
Mode:	Input/Output
Multi-band:	True
Default Value:	0
Validation Rule:	Any Value
Key Property:	No
Description:	Contribution of the generator to capacity reserves
Detail:

Input

By default the capacity provided by each generating unit to regional or zonal capacity reserves requirements is determined by the Generator Firm Capacity Basis setting, which defaults to the Max Capacity, but this can be overridden by defining Firm Capacity directly.

Firm Capacity is used in the calculation of Region (and/or Zone) Capacity Reserves in both PASA and LT Plan. For LT Plan it is the contribution each unit installed/built/retired makes towards any Capacity Requirement in that Region or Zone.

Example

Property	Value	Unit	Band	Date From	Date To	Timeslice	Data File
Units	100	-
Max Capacity	1	MW
Rating	0	MW					wind.csv
Firm Capacity	0.08	MW

This is typical input for a wind generator. The total installedncapacity in this case is 100 × 1MW = 100MW, but the Firm Capacity is only 8% of this, or 8MW.

Note: For the Firm Capacity to work, the Max Capacity must be defined as a non-zero value.

Output

Generator Firm Capacity as output is based on the input Firm Capacity if that is defined:

Firm Capacity = Firm Capacity × Units

otherwise:

Firm Capacity = Installed Capacity or Rated Capacity depending on Firm Capacity Basis