This setting governs how Aurora will handle missing data values in the Time Series Hourly table. Possible values range from 0 to 168.
When the field is greater than 0, Aurora will try looking at previous adjacent hours in the Time Series Hourly table to use for the hour that is missing data.
For example, suppose data is populated in the Time Series Hourly table for 1/1/2020 for all hours except for Hr 19 and Hr 20.
If the TS Hourly Missing Data Look Back Hours = 2, Aurora will use the entry for hour 18 for both hour 19 and hour 20, instead of the default value for the field (typically zero).
If the TS Hourly Missing Data Look Back Hours = 1, Aurora would use the entry for hour 18 for hour 19, but it would use the default value for hour 20 and send a warning to the Status window that data was missing.
NOTE: In general, when using the Time Series Hourly table values should be specified for all hours and this setting is meant to help provide a better default when a small subset of hours is missing. See the Time Series Generic table for entering data that is intended to be sparse.
TS Hourly Missing Data Look Back Hours
For further assistance, please contact Aurora Support.
Copyright© 1997-2024 Energy Exemplar LLC. All rights reserved.